Model Plane
I would like to make a model plane. Ideally it should be self controlling - but that will be hard, and is sure to be expensive.
So maybe it should be radio controlled, which is a bit easier and cheaper.
And as a step towards that, maybe it should not be controlled at all, and initially maybe it shouldn't even be powered...
Step 1: Airframe
If we start with a prototype airframe, I should be able to have some fun, and learn quite a lot, without spending much at all
- Choosing a design (or not - it should be easy to make something up)
- Inspired by (http://www.youtube.com/watch?v=BKUj6oGyqO4)
- Making some wings
- like this guy (http://www.youtube.com/watch?v=ckxnNRSM3YE)
- but probably using a "Clark Y" airfoil
- Making a tailplane
- Flat polystrene, or cardboard
- Joining them all up to a stick fuselage
- Test flying
Shopping list
- polystyrene (or styrofoam) for wings and tailplane
- Blue/Green "styrofoam" is available from Forman insulation (Port Rd, Seaview)
- Hot melt glue and gun
- Ice block sticks
- Velcro
- Stick for fuselage
- Modelcraft and hobbies
- Gordon harris
- Scrap timber from basement
Step 2: Powered flight
Small electric engines are cheap (modelcraft and hobbies), but need to make sure it doesn't fly away!
Step 3: Radio control
May need to scale up to a larger airframe, but by then it should be easy to build.
Need to learn about the wiring
Shopping list
- RC tranmitter
- at least three channels
- er9x firmware is open source, and is recommended by "the internet"
- supposed to work with this
- RC receiver
- servos
Step 4: Computer control
May not need the RC gear any more, but would need sensors, and a control unit (arduino?)